IMPACT GLASS SERVICES

How Glass Is Made

Posted On ›
November 2015

Glass has become one of the most popular building materials used today because it offers virtually unlimited aesthetic options, combined with outstanding performance. What ends up as large, sweeping glass panels in a high-rise office building, healthcare facility, school, or other construction project starts as a simple combination of sand, soda ash, limestone, dolomite and some other minor ingredients.


The glass making process commences in the batch house, which is where all of the incoming raw materials are offloaded on to a conveyer and sent to their respective storage silos. The actual batching begins when the raw materials are moved, weighed and mixed, and sent via a conveyor belt to the charging end of the melting furnace. The melting furnace is similar to an old fashioned brick baking oven, but much, much bigger.

The batch materials are combined with cullet (which is crushed scrap glass) and melted to form liquid glass. Sand is the major ingredient in glass, and sand on its own typically doesn’t melt until it reaches a temperature of about 3,000 degrees Fahrenheit. However, when sand is combined with other raw materials and cullet, it melts at a temperature well below 3,000 degrees Fahrenheit.

As the combination of batch materials enters the furnace, pre-heated air is pumped into the chamber by fans. The pre-heated air is then combined with jet streams of natural gas, which, in turn, produce torch-like flames that spew across the batch and cause it to react and melt in a matter of minutes.

The fining process is next. During this step, the bubbles that are formed during the melting process rise to the surface and escape into the chamber atmosphere. The glass then moves from the chamber through a canal into what is known as the float bath. The liquid glass floats as it hardens on a bath of liquid tin.

The glass moves under toothed wheels in the hot end of the float bath, which are known as stretch machines, to alter the thickness and width of the glass. In addition, heating elements above the stretch machines also control the glass thickness as it moves towards the exit.

The next step is cooling, which occurs with a series of water coolers in the cold end of the float bath. The glass is then carefully lifted out of the liquid tin and on to conveyer rolls at about 1100 degrees and goes into the annealing lehr. The job of the lehr is to further cool the glass at a controlled rate in order to ensure proper stresses are put into the glass so it can be cut easily and accurately.

The glass comes out of the lehr at about 350 degrees Farenheit and is then further cooled towards room temperature by open air fans. The glass is then inspected for any flaws prior to cutting. Before cutting, the glass must also first pass under a machine that drops a special powder on the surface in order to provide separation between each piece of glass and stain prevention